|
The TE1600
“WELD TESTER” is a
portable instrument
purposely designed for
measuring the parameters
of resistance welding.
By using probes of
different kind, the same
instrument enables to
measure both the welding
current and the force at
the electrodes.
The power of the 32-bit
microprocessor and the
accuracy of the 12-bit
A/D converter make the
instrument a highly
performing one.
It is suitable for
measuring on standard
machines in alternate
current (AC), direct
current three-phase
rectified and medium
frequency machines (DC)
and capacitor discharge
machines (CDW):
AC:
-
Measures
the
effective
value
(RMS),
maximum
value
and
average
value.
-
Measures
the peak
current
value:
maximum
positive
and
negative
value.
-
Measures
the
conduction
angle in
degrees.
-
Measures
the
welding
time in
cycles,
in ½
cycle
steps.
DC: Measures the
average value, the
maximum value and the
welding time in ms.
CDW: Measures
the peak value and the
welding time.
Pre- and post-blanking
function with
programmable time gap;
it prevents the
measurement errors when
the slope function is
used and it allows the
checkout of the correct
first insertion delay.
Stores the value
measured during the last
welds.
Measures the welding
force: it displays the
maximum force value, the
value at the beginning
and at the end of the
welding time.
Blanking function, it
prevents the measurement
errors due to high
impact force and it
allows to estimate the
latter.
Wide availability
measurement transducers.
Automatic recognition of
the connected sensor.
BNC output to display
the current wave-shape
on oscilloscope.
Supply by means of
alkaline batteries 4 x
1.5 V (size AA).
|
